DST PC

DST PC

Introduction
Thank you for choosing DST-PC, Diagnostic System Tester by DENSO.
DST-PC is Diagnostic System Tester for common rail system by DENSO.
Please read this manual well before using it for proper and safe use.
Functions
DST-PC is trouble diagnosis tool for common rail system by DENSO, and has following functions.

[Project]
 Manage project
  
[DTC]
 Read/Delete DTC
  
[Data Monitor]
 Monitor the value or information in ECU from Sensors, Actuators, Integrators and Adaptations
  
[Active Test]
 Compulsory drive of actuator such as injector
  
[Utility]
 Utility functions such as Injector compensation, Injection Quantity Correction, etc.
 

Install
It is needed to install communication interface driver and DST-PC (application) on your PC to use this software.
DST-PC can be used only when communication interface driver is installed properly.

IMPORTANT
Be sure to install as Administrator. Wrong action can be caused if you install as other user.
When installing communication interface driver, follow the instructions by installer and don’t connect communication interface with computer unless you are instructed. Computer might not be able to recognize communication interface if it is connected improperly.

NOTE
To use the DST-PC, be sure to log-in to Windows with administrator user account